I read all the posts about Powersupply voltage of 28V and defective PCBs. I am currently unsure, it my Dyson DC16 battery is charging as it should. If so the the power port is bad.Ġ15 0122.Try a different wall outlet to see if it helps. The plug cannot be held at the point where the sudden momentary flash takes place 1.With the AC power unit plugged in to the wall plug into your dvd player and wiggle it a little bit and see if the light goes on or off. The red charging light does not light up, and the player does not charge. But when I push the plug into the charging point on the side of the player,at one point, as the plug goes in, there is a quick flash of red - but no more. I want to recharge my Philips PET741 D/05 portable DVD Player. I examined the little circuit board inside but saw no visible indications that would isolate t. Anyone know a fix or a likely faulty component? I had a shark handheld about 8 years ago and it developed the same problem. Obviously there is a circuit failure in the on board charging control. ![]() ![]() So the power supply and the battery are both good. I can remove the battery and wire it to the power supply for charging and it will charge up and run the sweeper. ![]() ![]() The battery will not charge in the sweeper.
0 Comments
Leave a Reply. |